| Deel Nee | Fabrikant | Toepassing |
|---|
| MAX6378XR43-T | MaximIC | Ultra-low-power voltage detector, 4.3V |
| MAX542AEPD | MaximIC | +5V,serial-input, voltage-output, 16-bit DAC. INL (LSB) +-1 |
| MXD1000SA40 | MaximIC | 5-tap silicon delay line |
| MAX4503MJA | MaximIC | Low-voltage, dual-supply, SPST, CMOS analog switch. |
| MAX7403CSA | MaximIC | 8-th-order, lowpass, elliptic, switched-capacitor filter. Filter response elliptic (r=1.2), operating voltage +5V |
| MAX6319MHUK46D-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-high, push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 4.630V, reset timeout(min) 1120ms |
| MAX503CWG | MaximIC | 5V, low-power, parallel-input, voltage-output 10-bit DAC. |
| MAX6316LUK49DW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reser input,reser output active-low,push/pull).Factory-trimmed reset threshold (typ) 4.900V, min reset timeout 1120ms, typ watchdog timeout 6.3ms |
| MAX186ACCP | MaximIC | Low-power, 8-channel, serial 12-bit ADC. |
| MAX491CPD | MaximIC | Low-power, slew-rate-limited RS-485/RS-422 transceiver. Full-duplex. Data rate 2.5Mbps. Slew-rate limited - no. Low-power shutdown - no. Receiver/driver enable - yes. Quiescent current - 300 microA. Number of transmitter on bus - 32. |
| MAX735EPA | MaximIC | Negative output, inverting, current-mode PWM regulator. Converts +4V to +6.2V input to -5V output. |
| MAX130ACPL | MaximIC | 3 1/2 Digit A/D converter with bandgap reference |
| MAX6320PUK28BW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input, reset output active-low, open-drain).Factory-trimmed reset threshold(typ) 2.800V, reset timeout(min) 20ms, watchdog timeout(typ) 6.3ms |
| MAX6318MHUK46DW-T | MaximIC | Microprocessor supervisory circuit with watchdog input (watchdog input,reset output active-high,push/pull and active-low, bidirectional).Factory-trimmed reset threshold(typ) 4.630V, reset timeout(min) 1.12sec, watchdog timeout(typ) 6.3ms |
| MAX379CJE | MaximIC | High-voltage, fault-protected analog multiplexer. |
| MAX728CCK | MaximIC | 3.3V fixed output,2A step-down, PWM, switch-mode DC-DC regulator. |
| DG401AZ | MaximIC | Improved, dual, SPST, NO high-speed analog switch. |
| MAX6317HUK39AY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 3.900V, min reset timeout 1ms, typ watchdog timeout 1.6sec |
| MAX157AMJA | MaximIC | +2.7V, low-power, 2-channel, 108ksps, serial 10-bit ADC in 8-pin microMAX. INL (LSB) +,- 0.5 |
| MAX4051AEEE | MaximIC | Low-voltage, CMOS analog multiplexer |
| MX7524TD | MaximIC | CMOS 8-bit buffered multiplying DAC. TTL/CMOS compatible at +5V. Error +-1/4 LSB |
| MAX3490ESA | MaximIC | 3.3V-powered, 10Mbps and slew-rate-limited true RS-485/RS-422 transceiver. Guaranteed data rate 10Mbps. Supply voltage 3.0V to 3.6V |
| MX7541KN | MaximIC | CMOS 12 bit multiplying D/A converter. Error 1/2 LSB. |
| MAX6316MUK35DW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 3.500V, min reset timeout 1120ms, typ watchdog timeout 6.3ms |
| MAX912MJE | MaximIC | Single, ultra-fast(10ns), low-power, precision TTL comparator. |
| MAX275BC/D | MaximIC | 4th-order continuous-time active filter |
| MAX1241CEPA | MaximIC | +2.7V, low-power, 12-bit serial ADCs in 8-pin SO. INL (LSB) +1 |
| MAX6318LHUK27AX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 2.700V min, reset timeout 1ms, typ watchdog timeout 102ms |
| MAX633AEPA | MaximIC | CMOS fixed +15V output voltage, adjustable output with 2 resistors step-up switching regulator. 5% output accuracy. |
| MAX6317HUK50DX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 5.000V, min reset timeout 1120ms, typ watchdog timeout 102ms |
